Knauf Crawl Space Encapsulation: The Schertz Owner’s Guide
Knauf crawl space encapsulation repair and replacement in Schertz typically runs $2,800-$5,400 for a complete system, with most single-component repairs landing between $680 and $1,850. We stock Knauf-compatible vapor barriers, seam tapes, and drainage matting on our trucks, and we can usually get to Schertz homes same-day or next-day. Most owners first realize something’s wrong when they catch a musty smell drifting up through the floor registers or notice their dehumidifier running nonstop through a Schertz July.
Which Knauf Models This Applies To
Knauf’s crawl space line breaks down into three series you’re likely to find in Schertz homes built between 2005 and 2020: the 6-mil basic vapor barrier (white, unmarked edges), the 12-mil CleanSpace-compatible reinforced liner (Knauf part prefix KCS-12), and the 20-mil premium system with integrated drainage channels (KCS-20, mostly found in custom builds near the Crescent Ridge area). The label is usually stamped on the white tape seam, not the liner itself, which trips people up. If your tape has peeled and the label’s gone, measure thickness with a micrometer: 6-mil runs about the stiffness of a heavy-duty trash bag, while 12-mil feels closer to a pool liner.
We’re an independent service provider, not affiliated with Knauf. For the 12-mil and 20-mil systems, we typically install OEM Knauf seam tape (KCS-TAPE-4) because the adhesive chemistry is formulated for their liner surface energy. On the 6-mil basic, a quality aftermarket tape like StegoTack holds fine and saves you about $40 in material. The gotcha: Knauf’s 20-mil drainage channel spacing is 4.5 inches on center, not the 6-inch standard some aftermarket mats use. We’ve seen that mismatch cause standing water in two Schertz homes near Selma, where the installer eyeballed it.
Signs Your Knauf Crawl Space Encapsulation Is Failing

- Musty odor rising through floor gaps. The vapor barrier has torn at a seam or pier penetration, letting soil gas and moisture bypass the seal. In Schertz’s clay-heavy soils near Cibolo Creek, that moisture load is higher than the Knauf tape adhesive was specced for if the prep work skipped pH-neutralizing primer.
- Dehumidifier running continuously without reaching setpoint. Your encapsulated volume is no longer sealed; the dehumidifier is trying to dry the entire crawl space plus the soil underneath. We see this most in homes where the original installer used generic tape on Knauf liner, which releases around year 4 in Texas humidity.
- White or gray powder on the liner surface. That’s mold or mineral efflorescence, meaning moisture is condensing between the liner and the wall. The Knauf 6-mil system is especially prone to this if it was direct-applied to block without a drainage mat behind it.
- Sagging or pooling on the floor liner. The drainage mat has compressed or the sump discharge line is clogged. On Knauf KCS-20 systems, the integrated channels can get packed with silt if the pre-filter wasn’t maintained, and the water has nowhere to go but up.
- Increasing energy bills with no HVAC explanation. A failed encapsulation lets humid crawl space air infiltrate through rim joists and subfloor gaps. Your AC works harder to dehumidify air it already conditioned once. We’ve measured this with blower-door testing: a compromised encapsulation can add 800-1,200 CFM50 of effective leakage in a 2,000-square-foot Schertz home.
Replacement Cost & What’s Included
Here’s how pricing breaks down for Schertz:
| Scope | Price Range |
|---|---|
| Spot repair: tape + seam rework, under 20 linear feet | $680-$950 |
| Partial replacement: one wall or floor section, 12-mil | $1,400-$2,200 |
| Full encapsulation: 1,200 sq ft crawl, 12-mil, new dehumidifier | $3,800-$5,400 |
| Full encapsulation: 1,200 sq ft, 20-mil with drainage, sump | $4,600-$6,800 |
The range driver is condition of what we find underneath. If the old liner’s been trapping moisture against the sill plate, we stop and address that before laying new material. Every job gets a written price before any work starts, Haven Standard Clause 1, and a Documented Photo Record showing the sub-condition, the install sequence, and the final seam detail. The 365-Day Done Right Promise covers workmanship and material adhesion.
DIY or Call Us?

You can safely check three things: whether your dehumidifier’s drain hose is kinked, whether the sump basin has debris on the float switch, and whether any liner tears are visible from the access door without entering the space. What you shouldn’t do: crawl under with a box cutter and start peeling old tape. The 12-mil and 20-mil liners are heavy, the space is confined, and if your vapor barrier was doing its job, the air down there has been stagnant. More critically, if your home was built before 1985, disturbed insulation may contain asbestos; if there’s rodent activity, hantavirus is a real concern in Bexar County.
We carry Knauf-compatible tape, liner patches, and full rolls on the truck. Call (830) 402-5240 and we’ll read your situation with you, no charge. If you have a competing quote, bring it. Our Free Second Opinion means we’ll sit down and compare scope line by line.
FAQs
A properly installed Knauf 12-mil system with OEM tape and pH-neutralized substrate typically lasts 15-20 years in Schertz’s climate. The failure point we see first is tape adhesion at the perimeter, around year 8-12, especially on north-facing walls that stay damp longer. Call (830) 402-5240 for an exact quote on replacement - estimates are free.
Yes, if the damage is localized: a torn seam, a small puncture, or perimeter tape that’s released. We patch with Knauf-compatible material and roll the seam with a weighted roller. If the liner is brittle across the whole floor or mold has colonized the back side, partial replacement is the honest call. Call (830) 402-5240 for an exact quote - estimates are free.
A 1,200-square-foot crawl space with full removal, substrate prep, and new 12-mil Knauf liner takes our crew one full day. If we need to install a new dehumidifier or sump system, plan on two days. We don’t rush the seam cure time. Call (830) 402-5240 to check availability - same-day starts are possible if the scope is straightforward.
We stock Knauf-compatible 12-mil and 20-mil liner, KCS-TAPE-4 seam tape, drainage matting, and dehumidifier discharge line. For the 6-mil basic system, we carry aftermarket equivalents that match spec. If your job needs a full KCS-20 kit with integrated channels, we order direct and typically have it within 48 hours. Call (830) 402-5240 to confirm stock for your model.
Seal the leaks first. Then insulate. The attic doesn’t care how thick the insulation is if the air is still moving through it. Wes Okafor learned that sequencing the hard way, and we’ve applied the same discipline to every crawl space we’ve encapsulated in Schertz - including the tight, low-clearance jobs near FM 3009 where you can’t stand up straight and every seam has to be right the first time.
Written by Wes Okafor, Owner, Topside Attic Insulation Schertz at Topside Attic Insulation Schertz, serving Schertz and nearby areas.